Product Specifications for 1.2 Volt 800 mAh NiCd Cordless Razor Battery
| BM Part #: | BAT-RAZOR-8 |
|---|---|
| Voltage: | 1.2 Volt |
| Capacity: | 800 mAh |
| Type: | NiCd |
| Length: | 1.90" (48.32 mm) |
| Diameter: | 0.56" (14.22 mm) |
| Shipping Weight: | 0.12Lbs (1.92 oz) |
| Warranty: | 60 Day Return |
Product Description
This replacement NiCD cordless razor battery is made with high quality parts and is guaranteed to meet or exceed the original equipment manufacturers specifications at a reduced price.
Electric Shaver Battery. AA size with flat tabs. Rechargeable battery fits Norelco Maverick beard trimmers, Intercept models 2810 and 2830 and Remington models that begin with TA.
Cross Reference
- Norelco 138-10336
- Norelco 4822-138-10633
This battery can be used in these models:
- Eltron 4810
- Eltron 4830
- Norelco 20-XL
- Norelco 5625X
- Norelco 5812XL
- Norelco 600RX
- Norelco 6613X
- Norelco 6614X
- Norelco 6615X
- Norelco 6616X
- Norelco 6617X
- Norelco 6618X
- Norelco 6843XL
- Norelco 6844XL
- Norelco 6853XL
- Norelco 6856XL
- Norelco HP 2631A
- Norelco HP2750
- Norelco T-2000
- Norelco T-3000
- Norelco T-600
- Norelco T-6000
- Norelco T-660
- Norelco T-700
- Norelco T-7000
- Norelco T-7500
- Norelco T-760
- Norelco T-765
- Norelco T-800
- Norelco T-860
- Norelco T-870
- Norelco T-900
- Norelco T-960
- Norelco T-970
- Norelco WS400
- Norelco WS600
- Ronson RFS-3
- Wahl 5000
- Wahl 7040
- Windmere RFS-3
Customer Reviews
This battery restored my old razor. It works like new.
One minor gripe: the solder tabs were too wide to fit in the razor's circuit board. Nothing a wire clipper couldn't solve.
From a performance standpoint, this is a good replacement item. This battery lasts for at least one year, but at most, only two years. It works well until it quits, and then you have to replace it, which requires desoldering it from the electronics card. The performance I get is as good as the performance the original battery provided, and cordless operation is as long between rechargings as the original, though for a shorter time before a new battery is needed.
Note: Repeated replacement has necessitated adding jumper wires to complete the circuit, since repeated soldering caused the battery's contact pads to detach from the circuit board. Because I like using my Norelco T7500 trimmer, I have chosen to keep replacing the battery. (The original T7500 battery lasted much longer, but it was no longer being made, so I had to find a substitute.)
I replaced the battery in my Noreclo razor with this one and so far its been great. It lasts over a week on one charge where the last battery had to be recharged every 2-3 days and was erratic as well. This new one makes the razor run at consistent speed.
Good price. Fast shipping. Thanks Battery Mart.
Got it in surprising time frame. Item was as described. Soldered the tabs to the unit in place of the expired batteries. Charged overnight and shaver performs as new. No problems
Use it for my electric shaver. Working fine. Just a little solder and some knowhow...
I used a pair of these to replace the batteries in my old Remington R845 shaver (which had completely stopped working) and got it buzzing again! Just take note of the polarity and wiring on the old batteries, de-solder and remove them, solder these in, and charge them up.
