Power Bright PW6000-12 6000 Watt Power Inverter
Item #: PW6000-12   |    In Stock
Be the first to Write a Review

zoom in

Power Bright PW6000-12 6000 Watt Power Inverter

Item #: PW6000-12   |  In Stock
Be the first to Write a Review

Today's Price: $707.95
Free Shipping! Free Shipping

Price: $707.95

Best Value
Free Shipping
1 Year Factory Direct Warranty
Brand New
100% Compatibility
Secure Transaction

Product Specifications for Power Bright PW6000-12 6000 Watt Power Inverter

BM Part #: PW6000-12
Shipping Weight: 32.00Lbs
Warranty: 1 Year Factory Direct
Product Manual: Download
Datasheet: Download
  • Anodized aluminum case provides durability & max heat dissipation
  • Digital Led Display (Input DC Voltage or Output Wattage)
  • Built-in cooling fans turn on once the unit reaches 120°F (49°C)
  • Overload Indicator
  • Cordless Remote Control Included

Product Description

Free Standard Shipping!

Order today and receive free standard shipping on your Power Bright PW6000-12 6000 Watt Power Inverter. Only valid in the contiguous 48 states and not valid with any other offer. Physical address required (No PO Boxes).

This Power Bright 6000 watt inverter is a modified sine wave unit. Pure sine wave units are available upon request.

  • Continued Power: 6000W
  • Peak Load Power Rate: < 12000W
  • Input DC Voltage Rang: 10-15.5V
  • No Load Current Draw: < 0.6A
  • Output Frequency Range: 60 +/- 3Hz
  • Output Voltage Range: 117 +/- 10%
  • Max Power Efficiency: > 90%
  • Max Outer Temperature: < 65 C
  • Low Voltage Alarm Level: 11 +/- 0.5V
  • High Voltage Cut Off Level: 15.5 +/- 1V
  • Short Protect: Yes
  • Low Voltage Cut Off Level: 10 +/- 0.5V
  • Dimension (LxWxH) in: 26 x 8.9 x 6.1
  • Overload Protect: Yes
  • Input Voltage: DC 12V

Rate this description

Did you find the information on this page useful? Let us know!

Thank you for your feedback!

If you'd like to provide additional feedback, please fill out the form below. You may provide contact information if you would like our customer service to reach out to you.

Hooking into your Battery

This inverter has two DC cable connections, one positive and one negative. The order of steps in the following procedure minimizes the danger of sparking near the battery bank.

  1. Prepare all cable set ends with ring terminals at the battery ends.
  2. Install one fuse holder with fuse in the Pos cable close to the battery bank end.
  3. Make sure the ON/OFF switch located on the front panel of the inverter is in the OFF (O) position.
  4. Ensure all appliance cords or extension cords are disconnected from the inverter.
  5. Connect an AWG 8 stranded insulated wire to the enclosure ground terminal and connect the free end of the wire to the vehicle's chassis or any other ground point.
  6. Connect the unfused cable to the Negative (-) terminal of the battery bank.
  7. Connect the Negative cable to the Inverter's Negative (-) terminal.
  8. Insulate the end of cable to be connected to the Pos (+) Inverter terminal.
  9. Connect the fused cable to the battery bank Pos (+) terminal.
  10. Connect the Pos cable end to the Pos (+) inverter terminal.