Free ShippingProduct Specifications for PRO-LOGIX PL6100 12 Volt 100A Flashing Power Supply and 60/40/10A Battery Charger
| BM Part #: | PL6100 |
|---|---|
| Voltage: | 12 Volt |
| Charging Rate: | 60/40/10 Amp |
| Input Voltage: | ***Requires a 20A Outlet*** |
| Shipping Weight: | 25.00Lbs |
| Warranty: | 1 Year Limited |
| Product Manual: | Download |
Voltage Environment for module reprogramming by manufacturer (PDF): (Download)
Each vehicle manufacturer has a recommended target system voltage for reprogramming events. This document lists the required voltage environment to ensure safe, successful reprogramming by vehicle manufacturer.
- Power Supply Mode:
- Up to 100 amps Power Supply Mode to maintain system voltage.
- Adjustable from 13.1V to 14.9V to match OE specification.
- Provides optimal support for vehicle reprogramming and ADAS calibration.
- Minimal voltage ripple (<100mV)
- Rapid Load Response (RLR) technology for ultra-quick recovery from system demand increases.
- Charging Mode:
- 60/40/10A charging modes for quick, efficient charging of all battery sizes.
- Properly charges Flooded, AGM, Spiral Wound, Deep Cycle, and Marine batteries.
- Forced start mode allows charging of totally dead batteries.
- Battery repair mode overcomes battery sulfation to restore reserve capacity.
- Reverse polarity protection and battery fault detection.
- PowerJaw clamps with 13 ft. reach improve access to hard-to-reach batteries.
- PowerJaw clamps allow the hood to be closed (most vehicles) during ADAS calibration.
Product Description
The PRO-LOGIX PL6100 is designed to provide on-demand power up to 100 amps to a vehicle electrical system to support module reprogramming. It also provides 10 to 60 amp battery charging, servicing everything from small batteries to Group 31 batteries.
In power supply mode, the PL6100 maintains the vehicle's electrical system voltage at a preset level, increasing its output in response to system load increases to maintain a stable power environment. It features a voltage output range of 13.1-14.9V, adjustable in 0.1V increments, allowing you to dial the output exactly where it needs to be. It features fast load responsiveness for ultra-quick recovery from system demand increases. It delivers its massive power with minimal voltage ripple, providing a clean flow of power without programming interference.
In charging mode, the PL6100 precisely delivers a fully automatic charge designed for optimal changing and maintenance for each battery. It will charge a wide variety of lead acid battery types, including Conventional, AGM, Spiral Wound, Start-Stop, Deep Cycle, and Marine; virtually any lead acid battery installed in a vehicle. It will adapt its charging approach based on the needs of the battery or pack. Some approaches include activating a soft start mode on deeply discharged batteries, a repair mode on older & distressed batteries, and temperature compensation in extreme temperatures. Numerous safety features makes charging safer for the operator and vehicle/battery being charged, including over-voltage protection, reverse polarity protection, smart clamp technology, and battery fault detection.
