

Product Specifications for Battery Defender 24 Volt 4 Amp XLR Battery Charger
BM Part #: | 2409SR-WC |
---|---|
Voltage: | 24 Volt |
Capacity: | 4 Amps |
Shipping Weight: | 2.90Lbs |
Warranty: | 1 Year |
Additional Specs:
- Input Rating: Dual 100-240 Volts ~ 2A Max 50/60Hz
- Output Rating: 24 Volt ~ 28.8V Max 4 Amps
- Charges: Wet Flooded, GEL, SLA, AGM
- Includes: 3 Pin XLR
- U.S. Patent Pending
- Mainitaining your battery at full charge can help prevent sulfation.
- Dual voltage: 100 and 240VAC. This means you only need one charger for the whole world.
- Small size & light weight: Portability is a major feature. The charger can be installed on-board.
- One charger for any type of lead acid battery (no switch): Battery Defender Pro charger will charge any type or brand of lead acid battery fully, sealed or dry battery. The charger will adjust itself as the battery gets old
- Short circuit protection: If you touch the output Prove & -ve wires (with AC ON) and there will be no failure (no fuse will blow).
- Reverse polarity protection: If you connect the battery in reverse, there will be no failure (no fuse will blow).The charger will just not work. When the problem is corrected, the charger will operate normally.
- No current drain: If the AC is OFF and the charger is connected to the battery, there will be no drain of current from the battery.
- Low voltage start: Battery Defender Pro charger will start charging from 0.5 volts. This means a very deeply discharged battery can be charged. Other chargers cannot do this.
- Maintain full charge & no overcharging: can be left without harming (overcharging) the battery.
- LED Indicator: Orange: Charging Green: Charged
- UL, ULc (Canada), T-mark (Japan), TUV and CE (electrical EN 60335-1, Charger EN 60335-2-29, EMC - listed above) safety approvals.
This 24 volt, 4 amp battery charger is fitted with an XLR connector, which is commonly found in electric wheelchairs, studio equipment, and lighting applications. The charger is fully automatic and can maintain your battery at a full charge, which will help prevent sulfation.
- With 3 Pin XLR Connector for mobility scooters & wheelchairs including the hoveround
Note: Not for use on aviation batteries
TO CHARGE A HOVERROUND WHEEL CHAIR
Needed a charger for my Hoveround quickly and at a low cost as mine died. Shipping was fast! Charger worked just fine but the only way to turn it off or on was to plug/unplug it and the cord from the chair to the charger was too short...barely reaching the chair's hookup when placing the charger on the floor right under chair's hookup. Charger made no noise when charging so didn't know when done w
charging power chair.i wish i had bought one with a fan!
We needed a battery charger for my moms hoveround when the original one wore out after 10 years of use. This one is working great. It doesn't take up much room which is good since mom is in a double room in a nursing home. It is very similar to the original one so mom didn't have any trouble adapting to it.
NEEDED AN EXTRA CHARGER TO CARRY IN VAN WHEN OUT AND ABOUT.
Replaced orginal
Charges the scooter battery very quickly